Login
Login

THE ACTUATORS AND SENSORS (HOOC LORA)

Where there's an actuator, there's a sensor.


And where there is sensor, there you might need a low power/wide area-network (in our case LoRa). Because thanks to its modern wireless technology, LoRa can transmit smaller amounts of data over longer ranges, and this in a very efficent, power-saving manner. Speaking about savings: In order to be independent of external third-party providers and their pricing policies, HOOC has directly built its own LoRa network. So that the customer will benefit at all levels.


Résumé: A modern radio transmission with a deep in-door coverage that reaches into basements, electrical rooms and (almost) to the moon and back.



The sensors

MEASUREMENTS

ERS


The ERS is a battery-powered sensor with built-in motion detector as well as integrated antenna for measuring the indoor climate (temperature, humidity, brightness, etc.).


The perfect sensor for: motion detection and room climate measurement.



ERS-CO2


The ERS-CO2 has the same functionalities as a standard ERS sensor, but with an additional integrated CO2 measurement.


The perfect sensor for: motion detection, room climate and CO2 measurement.



EMS


The EMS is an approx. 50 mm small battery-operated sensor which, in addition to measuring the indoor climate, can detect water leaks and can also be used for door or window monitoring.


The perfect sensor for: room climate measurement, door and window monitoring as well as water leak detection.



ELT2-HP-ST


The ELT2-HP-ST is housed in an IP67 enclosure and is specifically designed for outdoor use. It has an integrated temperature and humidity sensor as well as a connector for an additional temperature sensor and a digital input.


The perfect sensor for: temperature monitoring, measurement in outdoor installations, dry contact as well as detection of water leaks (with add-on).







The actuators

REMOTE I/O

LW06-KIO


The LW06-KIO has four galvanically isolated 24 VAC inputs, one galvanically isolated 230 VAC input and two relay switch outputs.


Actuator with: 24 VAC inputs (4) + 230 VAC input (1) + relay switch outputs (2).



LW13-MIO


The LW13-MIO has sixteen galvanically isolated 24 VAC inputs and eight relay switch outputs.


Actuator with: 24 VAC inputs (16) + relay switch outputs (8).



LW13-IO


The LW13-IO has a galvanically isolated 230 VAC input and a relay switch output.


Actuator with: 230 VAC input (1) + relay switch output (1).






ALL IN ONE

SENSOR AND ACTUATOR

LW12-MET


The LW12 has a galvanically isolated 230 VAC input and a relay switch output. The device also includes a sensor that can measure the power consumption of a 230 VAC consumer (up to 16 A).


The perfect sensor for: energy consumption measurement.


Actuator with: 230 VAC input (1) + relay changer output (1).